Designed specifically for conducted EMC testing, this mismatch tolerant Class A amplifier is ideally suited to provide power into a CDN for IEC 61000-4-6 conducted susceptibility testing up to and beyond the normal 10 V emf test level.
The Class A design ensures a high reliability, low distortion linear performance across the frequency range. This design also ensures that the amplifier will continue to operate at full power even when presented with an open or short circuit at its output.
The unit is powered from a switched mode power supply for high efficiency, high power factor and wide voltage range operation. The unit is air-cooled with integral fans, and is protected against faulty cooling by excess temperature sensing. Front panel indicators are provided to indicate over-temperature.
|Frequency range (instantaneous)||
0.15 to 230 MHz
|Rated output power||
35 W minimum (37 W typical)
|Output power at 1 dB gain compression||
25 W minimum (30 W typical)
|Harmonics at P1 dB||
|Power Supply Voltage||
|Power Supply Phases||
AMETEK CTS GmbH
4153 Reinach, Switzerland
Tel.+ 41 61 204 41 00
Manfred A. Bergsch
Astrid Wälchli Schreiber
Register of companies: CH-280.4.015.069-3