Back to home
Ametek
 

CVP 2200A

Capacitive Voltage Probe

CVP 2200Azoom
  • CISPR 22 (EN 55022), CISPR 32 (EN 55032) and CISPR 16-1-2 compliant
  • Battery or DC power supply
  • Switchable conversion factor
  • Shielded to reduce the direct capacitive coupling from local cables
  • Calibration fixture included
 

The Capacitive Voltage Probe (CVP) is designed for measuring asymmetrical disturbances on cables with capacitive coupling principle. It gives the opportunity to do the measuring without disconnection of the tested cable (“in-situ”) and it avoids the influence of the transmission. Main parameter of the CVP is the coupling factor, measured in a calibration system with 50 Ω impedance. The capacitive voltage probe is specified in chapter 5.2.2 and Annex G of CISPR 16-1-2.

 
Parameter Value

Frequency range

150 kHz to 30 MHz


RF voltage range (in relation to a noise figure of the receiver F ≤10 dB)
Sinus voltage (average, BIF = 9 kHz CISPR 16-1)
Upper limit (A1, 1 dB- compression): 150 dBμV
Lower limit (A3, f ≥1 MHz, noise error ≤1 dB): 26 dBμV
Pulse voltage (Quasi-peak)
Upper limit (A1, pulse frequency: 100 Hz): 74 dBμV

Overload indicator

for sinus and pulse voltages

Correction factor k1
(only valid for a cable diameter of 22 mm)

A3: 20 dB
A2: 30 dB
A1: 40 dB

Frequency response correction factor k1

A3: ±1.2 dB
A2: ±0.8 dB
A1: ±0.8 dB

Datasheet

Gallery

 
 
 
 

Imprint

AMETEK CTS GmbH
Sternenhofstr. 15
4153 Reinach, Switzerland
Tel.+ 41 61 204 41 00
marketing.cts@ametek.com

Managing Directors:
Manfred A. Bergsch
Astrid Wälchli Schreiber
VAT-ID: CHE-179.452.414
Register of companies: CH-280.4.015.069-3


 
 
By continuing to use the site, you agree to our Privacy and Cookie Policy.